You are using an outdated browser. Unfortunately, this does not allow us to guarantee that our website can be used without any errors. The use of outdated browsers often leads to low speed and security problems, too. We recommend that you install a new version or an alternative browser to get the full functionality of our website.
Type 8081
- Flowmeter for continuous measurement of water
Specific products may differ slightly from the general images shown.
Please consider the technical attributes.
Type Description
The ultrasonic flowmeter Type 8081 is designed for measuring the flow rate of water, also with water with low levels of contamination. It consists of an electronic module and a brass fitting with integrated measurement tube. A flow control system can be set up very easily by combining the device with a controller and a control valve. The electrical connection is via a 5-pole M12 device plug. Depending on the variant, the device comes fitted with the following outputs: - a pulse output or - a pulse output with a 4-20 mA current output. Every variant comes with 5 The ultrasonic flowmeter Type 8081 is designed for measuring the flow rate of water, also with water with low levels of contamination. The device consists of a brass fitting with integrated measurement tube and a transmitter. It is available in 5 variants: QN 0.6 DN 15, QN 1.5 DN 15, QN 2.5 DN 20, QN 3.5 DN 25, QN 6.0 DN 25 with flow volumes ranging from 0.06 l/m to 20 l/min (nominal flow rate 0.6 m3/h, i.e. 10 l/min), from 0.1 to 50 l/min (nominal flow rate 1.5 m3/h, i.e. 25 l/min), from 0.16 to 82 l/min (nominal flow rate 2.5 m3/h, i.e. 41 l/min), from 0.6 to 116 l/min (nominal flow rate 3.5 m3/h, i.e. 58 l/min), or from 1 to 200 l/min (nominal flow rate 6.0 m3/h, i.e. 100 l/min Each variant is fitted either with a pulse output or a pulse output and a 4-20 mA current output. The electrical connection is via a 5-pole M12 plug. A control circuit can be created by combining the device with a controller and a control valve.
Ultrasonic flowmeter operating according to the time of flight (TOF) principle
Dynamic area ≥ 1:250
Minimal pressure loss
No calming sections required at the inlet or outlet
To help select the correct product please refer to the technical data, images and notes for proper use found in the data sheet.